2 day shipping & overnight available. Call for rates! 248-895-6013
Use of multiple battery banks dictates that the batteries be connected or "integrated" only whenever a charge voltage is present so that they may be charged simultaneously, then disconnected or "isolated" when in use to allow for selective discharge and avoid having the secondary or standby battery drain into the primary battery. The new Battery Integrator performs this function automatically, acting as a "smart" switch to connect independent battery banks only when a charging voltage is present. Otherwise, they are isolated, and discharge between banks is prevented.
The traditional rugged and reliable diode isolator can also be used for this function, as it also maintains isolation between banks and allows charging from multiple sources. However, one drawback is inefficiency when voltage is lost as current passes through the diodes, resulting in undercharge if the charging source does not compensate for the voltage drop.
The Battery Integrator remedies this by use of an extremely low resistance contactor which causes no voltage drop in the charging system, while the multiple batteries are charged as a single bank whenever a charging source of approximately 13.2 VDC or 26.4 VDC or greater is present (depending on model).
When the alternator or charger is off or a large load causes the voltage to drop below the disconnect point the unit breaks the common tie between the banks. This allows selective battery discharge and prevents "dumping" of a higher-charged bank into a lower-charged bank.
The unit may also be activated through the key starter or a manual switch to provide an added "boost" from the secondary battery whenever the starter is engaged and the unit senses there is sufficient voltage in that battery to provide an assist.
For systems with more than two banks, an additional unit may be installed for each additional bank to provide the same isolation and integration as described above.
The Battery Integrator is ideal for multiplying the single charging output of an inverter-charger to maintain both the house bank and an engine start bank, then to isolate them during inverter function, so current is drawn from the house bank only.
Features
Enables charging of two separate banks without voltage drop, yet maintains 100% isolation at all other times. For systems of three banks or more, an additional unit may be installed for each additional bank
Heavy duty silver-plated contactor, continuous duty rated to 100 amps
Voltage sense circuit, epoxy encapsulated and heavy duty continuous rated solenoid are all designed for use in marine environments
Easy-to-install: compact size - may be mounted with any orientation
Easy three-wire hook up for two bank systems (BATT +, BATT +, GROUND)
Terminal for optional wiring of remote light indicating when battery banks are integrated
Optional internal connection can be wired though key starter or manual over ride switch, tying battery banks together for extra boost during engine start
Rates from 0%-36% APR. Payment options through Shop Pay Installments, are subject to an eligibility check and are provided by these lending partners: affirm.com/lenders. Options depend on your purchase amount, and a down payment may be required. State notices to consumers https://www.affirm.com/licenses.
Facebook Client Reviews
Where do I start! This man is a genius, I may have ordered a amateurs dream from this man, went all out on garmin products from gpsmap screens to the live scope lv34 and to juice them up I went with all powerhouse batteries and charging units! Well now on the boat I’m staring at this out dated minnkota and it just looked out of place so I went ahead and ordered up the KRAKEN! I can’t stop bragging on how much you have helped me, even face timing me on the water to fine tune my Livescope, there is no big box store that could even come close to offer this level of customer service! You will forever be my go to company! Thank you again!
Yoshi Johnson, Illinois
Very fast shipping. Very knowledgeable guy to deal with. I inquired after hours and Chad responded quickly and chatted with me for way longer than necessary because I knew nothing about livescope. Who offers there cell phone number to call with any install questions??? Chad does. I got a friend request from him and accepted. Felt like I bought from someone who values my purchase as well as my friendship. We may never meet but I feel like I have gained a great friend. Thanks Chad for all your time spent explaining what I wanted and giving me choices. This won't be my last purchase..
Mark Teel, Texas
It has been a pleasure dealing with Chad at Chaddy Boys! I had contacted him many times on the phone and has been very helpful! I felt like we had been old friends for a long period of time! Chad sent me many quotes and was very helpful on choosing the electronics setup I was seeking! I ordered my unit and received it on exact date I was quoted! I will definitely be buying from Chaddy Boys again!
Shane Bramlett
This 16 volt battery and Run and Gun Charger is the only way to outfit your boat. Fish all day with no worries. Chad is very knowledgeable and helpful with the everything you need for a great day on the water. Now just waiting for a 36 volt to have the perfect setup. Thanks Chad.
Update* Well we just installed the second battery and run and gun charger. Took out 3 lead acid and about 120 lbs. Looking forward to the new system. Gonna be awesome. Thanks again Chad
Heather & Randy Moore, Florida/Canada
School of Large Mouth on side imaging
We offer on the water Face-Time calls for product install, setup & graph tuning for side-Imaging, down-imaging & livescope! I took this side scan image 4 years ago. How many fish do you count?
Lets get it straight, we’re anglers first..
Never trust a skinny chef. My staff & I are all believers in the product we sell & USE. Whether it’s weekends at the lake, Wednesday night derbys, or the Bassmaster Elite Series. We've got you covered. We pride ourselves on answering the phone & providing you excellent customer service.